Activate the Direct Call from the Allevo main module

ALLEVO_ACTIVE

* effective from version 3.3

This constant activates the current scheme for the direct call from the Allevo main program (entry X in column Value from).

Enter X instead of R in order to call up the scheme in the satellite for reading data from CO/PA only and enter W for planning only in CO/PA.

In case that all column definitions of an Allevo layout are being used to determine the Read/Write parameters (and the corresponding interface table is completely blank), you may also use T to determine that all data per column definition shall be transferred to CO/PA at the same time as a table (according to the „total-or-single-marking“ in the last column of the Read/Write parameters).

When adopting plan data in the Allevo main module, all CO/PA schemes with the active constant ALLEVO_ACTIVE are being executed.

Optionally, you may restrict the execution of a scheme to single Allevo layouts: enter the layout in column Value to (possibly multiple layouts, separated by comma).  

Note:

If you do not enter any scheme in the selection parameter upon Allevo CO/PA execution via the dialog transaction, again all schemes with the active constant ALLEVO_ACTIVE will be executed. If you enter * for the scheme, all satellite schemes will be executed! For some constants, you will need reference to an Allevo layout when executing Allevo CO/PA (e.g. for reading an Allevo column definition): the layout will be included when calling directly from the Allevo main module; in the dialog mode, Allevo CO/PA uses the first layout in column Value to (or the * layout, if none is stored in the constant).