Dynamic Z: Read via Partner Objects

DYN_Z

* effective from version 2.6.1 (restricted significance from version 3.0 see below)

The dynamic range Z in Allevo allows to dynamically read activity relations and considers the respective partner object as sender (activity input from activity allocation).

The constant DYN_Z controls this function on the side of SAP: entering "-" in column Value from deactivates the dynamic reading of activity relations.

Note:

Generally, the dynamic ranges are activated by the corresponding row definition in the Allevo Master. If these are not available in the Master, the dynamic range is inactive, even if "-" is not set for the constant.

By entering V in Value to, the Allevo Master will display the values in period columns instead of quantities.

Warning:

The planning of input activities is a planning of quantities. If planning by row is also carried out, the values shown in the period columns are interpreted as quantities. C is usually set as row definition for reading and writing values.

Restricted significance from version 3.0 onward with new period planning for more than two years.

· A “–“ in column Value from still deactivates the reading of data for the dynamic range X.

· Entry of V in column Value to, however, is no more efficient since the distinction between quantities and values is now performed via column definitions in period columns.

Note:

The constant DYN_Z refers only to the dynamic range Z. Reading the ranges X and Y is controlled via the constants DYN_X and DYN_Y.